Veneer Systems, Inc. » Product » MPA II - precatalyzed crosslink PVA - 1 ... View Cart | View Account | Advanced Search  
Category Index
New Items (24)
Featured (28)
Release agents (3)
Bessey Clamps (9)
Veneer Tape
& Dispensers
Veneer Adhesives (25)
Glue Applicators (20)
Veneer Hand Tools (36)
Miracle Veneer Trimmer (2)
Vacuum Pressing (60)
Veneer Softener (2)
Zig Zag Products (11)
Hot Press Products (9)
Books & Videos (10)
Famowood (23)
Veneer Equipment (18)
Case Clamps (3)

Product Search
Advanced Search


Shopping Cart
   Your cart is empty.   
Subtotal: $0.00
View Cart | Checkout

Veneer Systems
About Us
What's New
Request a Catalog
Parts and Service
Terms & Conditions
Privacy Notice
Contact Us
Item List

MPA II - precatalyzed crosslink PVA - 1 gallon

SKU#: Precatalyzed Adhesive - MPA II - 1 gallon
Our Price:

Product Overview

Precatalyzed crosslink PVA

Product Details

Type: Cross-link Emulsion – White

A stable, non-thixotropic, self-crosslinking emulsion which is best suited for RF high frequency edge gluing and hot press veneering. Provides excellent bonds and high shear strengths on hardwoods (ie. Oak, ash, pecan, maple, etc.). Designed as a precatalyzed adhesive which elimnates mixing and exceeds Type II water resistance criteria (ANSI/HPMA 1983). It is also suitable for cold press applications.

For RF high frequency edge gluing of wood to wood and wood to wood composites, hot press veneering and cold press applications.

* Environmentally friendly – no voc, non-polluting
* Medium to fast set speed
* No mixing
* Good water resistance (full Type II)
* Bond provides high shear strength values on maple (>3000 psi; ASTM D 905)
* Good heat resistance

Directions for use:
* All wood substrates should be conditioned at room temperature at 6-9% moisture content
* A 6-9 mil spread is adequate
* A lighter spread is typically used for hot pressing. Consult your rep. for recommended press cycles
* Open assembly time is 5 minutes, but is dependent on porsity of the substrates, ambient temperature and quantity applied
* Closed assembly time is 10-15 minutes. Adhesive should be “wet” when the assembly is placed in the press equipment
* Clamp time for cold pressing is about 1 hour. Allow to cure 24 hours before machining

Use warm water if the adhesive is still liquid. Hot water may be used if the adhesive is dried

Can be stored in factory sealed containers for 6 months @ 77 F

Veneer Systems Inc.
145 Gruner Road
Buffalo, NY 14227

Toll Free - USA & Canada
Tel: 800-825-0840
Fax: 877-871-1733

Veneer Systems, Inc. ©Copyright Veneer Systems Inc.