A PVA with fibrous fillers to minimize bleedthrough on open pore species.
Excellent adhesive with moderate set speed & good heat resistance. Minimum use temperature 35F.
MPA Veneer ľ Tan
Type: Polyvinyl Acetate Emulsion
Moderate set speed. Good heat resistance. Low minimum use temperature. Long storage life. Meets ASTM D 4317-86 Type III specification.
Excellent adhesive for laminating veneer or high pressure laminates to a given substrate, as well as general assembly gluing where a heavier, filled product is desired.
Directions For Use:
* Moisture content of veneer should be 6 to 8%
* Apply with roller or roll spreader to the core being used
* Assembly time is 5 to 15 minutes depending on temperature, moisture content, species & porosity
* Dead stack overnight before machining
Cleans up easily with warm soapy water while still wet.
Cool temperatures - 55░ to 80░ ideal.
Veneer Systems Inc.
145 Gruner Road
Buffalo, NY 14227
Toll Free - USA & Canada