To splice veneer using Urea or PVA adhesives with integrated glue application system

Integrated splicer glue applicator
- Consistent adhesive dosage
- Eliminates additional machine or spray system
- Eliminates airborne contaminants and/or additional investment

Two direct drive motors and single speed control frequency inverter.
- There is no opportunity for loose linkage
- There are far less wear parts
- Both motors are adjusted with the same control, ensuring synchronous speed.

Thickness from 1/10th to 1/64th
Minimum width - 1 ½ inches
Minimum length - 12 inches
Heating zone length is 39 inches
Variable speed 33fpm to 131fpm
Air pressure compensation for bucked and wavy veneer
All chains and chain pins are made with specially treated stainless steel.

Throat depth is either 39, 48.5 or 55 inches
Throat height clearance is 19.5 inches
Operating voltage is client specified
Power required is 6kWhr
Compressed air at 84psi, 1cu.ft. min
Table height 36 – 39 inches
Footprint approx. 6ft x 6ft
Weight 2800lbs